Mark VI tank

The Mark VI was a British heavy tank project from the First World War.

Design

After having made plans for the continued development of the Mark I into the Mark IV, the Tank Supply Committee (the institute planning and controlling British tank production) in December 1916 ordered the design of two new types of tank: the Mark V and the Mark VI. The Mark V had to embody the most advanced features that could still be incorporated into the Mark I hull. The Mark VI should abandon the old hull entirely, reflecting only some general principles of the older tank.

On 13 July 1917, Metropolitan, the firm associated to Sir William Tritton, had a wooden mock-up ready of both models. As no design drawings of the Mark VI have survived, the pictures made on that date (and earlier on 23 June 1917 of the still partly unfinished models) form the major source of information.

The Mark V design still looked a lot like the Mark I. It had many changes in detail however, including smaller sponsons with cylindrical machine gun mounts, a lengthened hull, a larger cabin and a machine gun position at the back. This design was ultimately abandoned due to enormous delays in the development of the Mark IV. The tank eventually taken in production under that name was not the Mark IV, as originally planned, but basically a slightly changed Mark I. When at last in December 1917 the desired new engine and transmission could be built in, it was this type which became known as the Mark V.

The Mark VI design had a completely different hull, which was higher with rounded tracks on the front. It had no real sponsons; the side doors replacing them having protruding machine gun positions. The main armament was a single 57 mm gun low in the front of the hull. The driver is sitting in a square superstructure much further back, the corners of which each had a machine gun.