Curtiss Model F

The Curtiss Models F made up a family of early flying boats developed in the United States in the years leading up to World War I. Widely produced, Model Fs saw service with the United States Navy under the designations C-2 through C-5, later reclassified to AB-2 through AB-5. Several examples were exported to Russia, and the type was built under license in Italy.

Design and development

In configuration, these were biplane flying boats powered by a single engine mounted amongst the interplane struts and driving a pusher propeller. The pilot and a single passenger sat side by side in an open cockpit. The wing cellule was derived from the Model E landplane and was of two-bay, unstaggered, equal-span construction with large ailerons mounted on the interplane struts and extending past the span of the wings themselves. The earliest examples of this design were built and sold by Curtiss in 1912 without any designation applied to them; the Model F name only coming into use the following year. Confusingly, Curtiss also used the designation Model E to refer to some early machines in this family, although these were quite distinct from Curtiss landplanes that bore this same designation and all but identical to the Model Fs.

Model Fs built from 1918 featured a revised, unequal-span wing that incorporated the ailerons into the upper wing and sponsons on the sides of the hull to improve the aircraft's handling in water. These were known as the Model MF (for Modernised-F), and years later as the Seagull in the postwar civil market.

Operational history

The US Navy initially purchased four of these aircraft in addition to the Freak Boat (C-1/AB-1) that it had already obtained and which was retrofitted to approximately the same design as the others.